Easy Ways to Fix Bumps in Roman Clay Wallpaper

Roman clay wallpaper gives walls a beautiful, textured finish that mimics the look of smooth clay or plaster. But sometimes, bumps or bubbles appear, which can ruin the seamless effect. If you’re dealing with bumps in your Roman clay wallpaper, don’t worry! Here are some easy, beginner-friendly ways to fix these imperfections and get that smooth, sophisticated look back.

1. Identify the Cause of the Bumps

Before you begin, it’s helpful to understand what’s causing the bumps. Here are some common reasons:

• Air bubbles trapped during the wallpaper application.
• Moisture issues, which can cause wallpaper to loosen and create bubbles.
• Improper wall preparation (like not smoothing the wall) before applying wallpaper.

Knowing the cause will help you choose the best solution. For example, if moisture is an issue, you may need to address the source of the dampness to prevent future problems.

2. Use a Wallpaper Smoother for Small Bumps

If you notice small bumps or air bubbles shortly after applying Roman clay wallpaper, a wallpaper smoother can often fix the issue. Here’s how:

• Step 1: Gently press the wallpaper smoother against the bump and smooth it from the center of the bubble outward. This pushes trapped air toward the edges, allowing it to escape.
• Step 2: Continue to press and smooth until the wallpaper lies flat against the wall.

A wallpaper smoother is affordable and can usually be found at most home improvement stores. It’s an easy way to get rid of small bumps without using other tools.

3. Use a Pin to Release Trapped Air

For larger bubbles, you may need to use a pin to release the trapped air:

• Step 1: Gently poke a small hole in the center of the bubble with a fine pin or needle. Be careful to make the hole small so it’s less noticeable.
• Step 2: After poking the hole, use a wallpaper smoother or your finger to press the air out through the pinhole.
• Step 3: Smooth over the area to ensure the wallpaper lies flat.

This method works well for bubbles that are stubborn and won’t go down with just smoothing. The small pinhole is usually unnoticeable once the bubble is removed.

4. Apply Wallpaper Adhesive to Loose Areas

If a bump or bubble appears because the wallpaper is starting to peel away from the wall, a small amount of wallpaper adhesive can fix it:

• Step 1: Lift the edge of the loose wallpaper carefully, just enough to apply some adhesive.
• Step 2: Use a small brush to apply wallpaper adhesive to the back of the lifted area.
• Step 3: Press the wallpaper back onto the wall, smoothing it down with your hand or a wallpaper smoother.
• Step 4: Wipe away any excess adhesive with a damp cloth.

This approach works well for bumps caused by loose wallpaper edges and helps secure the wallpaper back to the wall.

5. Avoid Future Bumps by Preparing the Wall Properly

One of the best ways to avoid bumps in Roman clay wallpaper is to prepare the wall before applying it. Make sure the wall is clean, smooth, and dry. Sand down any uneven areas, fill in holes, and clean off dust or dirt. This creates a smooth surface that helps the wallpaper adhere evenly, preventing bubbles from forming in the first place.

Final Thoughts

Fixing bumps in ROMAN clay wallpaper paste is easier than it may seem. Whether it’s by using a wallpaper smoother, poking small bubbles with a pin, or reapplying adhesive, you can tackle most bumps quickly and effectively. With a few simple tools and a bit of patience, you can enjoy a smooth, beautiful Roman clay finish on your walls.